MyVersacamm.com

A Digital Printing Network

Has anyone tried printing directly on 030 magnetic material? I was told that I could do this if I raised the head. I far as I can see there is no height adjustment.
Thanks Bob

Views: 4

Comment

You need to be a member of MyVersacamm.com to add comments!

Join MyVersacamm.com

Comment by Carolyn on April 29, 2010 at 3:29pm
thanks
Comment by Steven Jackson on April 29, 2010 at 3:25pm
You can do it that way and with the 300 unit, I would recommend it! Most of the pre cut magnetic material places I have send will give you the vector outline for the design to use.
Comment by Carolyn on April 29, 2010 at 3:13pm
so I would need to buy pre contoured magnetic material, decal media, print, apply and trim after application?
Comment by Steven Jackson on April 29, 2010 at 2:57pm
You cannot print directly onto magnetic material with a 300 unit. You will need to print onto decal vinyl and then apply it to the magnetic material.
Comment by Carolyn on April 29, 2010 at 2:47pm
so does this mean we can not print on magnetic material if we have the 300i?
Comment by Steven Jackson on December 8, 2009 at 10:33am
Please re post this in one of the forums to maximize responses if desired.
Comment by Steven Jackson on December 8, 2009 at 10:33am
On the 300 units you cannot adjust the head height. You can only adjust the head height on a 540 unit.

© 2012   Created by Adam Yukish.

Badges  |  Report an Issue  |  Terms of Service