A Digital Printing Network
Magnetic Material
I am trying to do magnetic material in the printer. I keep getting a sheet loaded wrong error and turn off the motor/power.
I don't have any idea what I'm doing wrong....I would appreciate any help.
Thanks
Comment
-
Comment by Adrienne Mignano on November 19, 2010 at 11:25am -
I actually printed on vinyl and cut it to the shape of the magnet and then just applied the vinyl to the magnet with soap and water....came out great..very professional looking, and I didn't have the wear and tear on the printer with cutting the heavy magnetic material....I manually cut the magnets...they were just square shaped...guess I would have to figure something else out for odd shapes....
-
Comment by Jim Ashby on November 19, 2010 at 11:18am
-
I know this is a little late. What was the remedy to this. I am getting ready to try a short run job direct to magnetic. My understanding is that you should be able to do this on the Roland printers.
-
Comment by Candy Mattingly on May 10, 2010 at 11:34am -
ALSO PUTTING IT ON THE MAIN PAGE MIGHT GET YOU MORE HELP!
-
Comment by Candy Mattingly on May 10, 2010 at 11:33am
-
ARE YOU TRYING TO PRINT AND THEN CUT WITH MAGNETICS. ARE YOU PRINTING RIGHT ON TO THE MAG. I JUST WONDERING A LITTLE MORE INFOR MIGHT HELP!
© 2012 Created by Adam Yukish.
You need to be a member of MyVersacamm.com to add comments!
Join MyVersacamm.com