I work with Roland VP540.
I had problems printing and decided to change heads, but there was a problem - not printed at all, I did change according to the service manual. Then I noticed that the fuse F1 of Main Board is burned, I change the it but burned again. The fact is that somewhere it is a shield circuit but do not know where to find him.
Think you can help me with some advice, I know of F1 and F2 coordinates the 4…
Added by Farkas Alexandru on November 23, 2012 at 10:30am — No Comments
Is there a tip or trick to re-attaching pieces of Heatsoft (or other material) that comes off during weeding (like the dot on an "i")? The backing material is not sticky and I don't want the errant piece to move when masking.
I have a BN-20, Versaworks,create my work in Corel X5. I prefer to export the files as a PDF, Corel files are not the same colors,etc.The PDF files print perfectly. The problem is that the PDF files do not recognize the cut line. The EPS will. Can anyoe help?
Where could I find the media profile for roland sp300v for the Arlon DPF6000XRP?