May 2012 Blog Posts (5)

Hoping someone can help on this one. I just printed a104" piece of glossy wrap and the print has faded stripes.


In our ongoing saga our next question is:

We were finally about to cut but there is a white edge of the media on PARTS of the letters but not around all of the letters.  I set the contour the same around everything.  Can anyone help me understand why the media would show around only some of the letter?  Is the offset of the blade a problem?  It was set at 250 but I see the range is from .01 and up.

Thanks in advance.

As we move along in learning our versacamm our new problem is the media keeps getting crunched as the heads go back and forth printing.  We are using imprintables spectra t shirt media that we heat press on shirts.  We have an old CJ500 that has been converted to a SC500. 

Everything goes fine for a time but then the one edge of the paper gets crunched.  It is firmly on the rollers when printing begins.  Is there an adjustment of the head we need to make?

Simplified my home network by removing an old hub and router and using the internet modem to route both wireless and wired.  Went to print to the Versacamm today but the printer won't connect.  Have restarted everything, disconnected and reconnected, verified network(s) and tried to reinstall to no avail.  Any ideas.  I've got work to get out.

Cindy

We are very, very new to the cutting of a corel design with my roland.  I have letters that consist of a block letter with an 8 pt black outline as the back layer with a block letter and a 4 pt white outline as the top layer, making the shadow effect.

I convert curves and add my countour cut line, but it keeps appearing INSIDE the black outline and cuts the black out.

I've tried boundary and countouring every way I can figure.  Obviously there is a setting/trick I don't know…