Hello, I recently got my versacamm running after replacing the print head, mother board, and data cables. It prints great. I just started working with the heat transfer print and cut (colorprint PU…Continue
"Thank you for your reply Irving,
as I mentioned in my first post, I replaced the mother board and most of the data cables, along with the print head, I cant loose hope! The tech cleaned out the machine pretty good, except the coded disc…"
"The issue is that folks (not only you) do not state what actually happened, then folks like me have to guess what actually happened and what we are seeing.
Machines when transported, should be uninked and head locked in place. When any ink…"
"I believe it is a lot less then 20 feet, I tried another design that has very little cuts and only printed 1 row, I got a clean cut, then after resending it again the cut would be off. I tried it again for a 3rd time and the cut is good. Its on and…"
"It would go off cut ,off the start on some cut jobs with 2 rows. Then I would load again to try the same exact print and cut and it would cut ok. It was hit and miss all day on only printing 2-4 small rows at a time, less then 2 feet each time."
"You get accurate cuts up to 8 linear feet. Take your cuts lines and stretch out to 8ft and after that they can be off. So how many rows before it went off. Next time do that number only. It will take longer but no longer than throwing away wasted…"
Hello, I recently got my versacamm running after replacing the print head, mother board, and data cables. It prints great. I just started working with the heat transfer print and cut (colorprint PU 29') It started off fine, I did several rows with no major off cuts, Then I ran 4 rows and suddenly the cuts were way off! So I ran a single row to test and the cuts came out fine. So I tried again and the cuts were way off. This went on all day, as I needed to get an order done today. I wasted a…See More