Steve Janell Sacharski's Page

"I got a blade a while back that must have been a fraction over diameter on the shaft and messed up my cutting, changed blade and problem went away."

"can you cut magnet material on a VP300, I have been doing the print on vinyl and then cutting by hand  "

"Paul your sorry I only have 8"

"No NO NO No Pick me, ( Do I have 10 yet :-))"

"Thanks!"

"we switched to Sisser Evolution and really love it, mylar backer with light adheisive, thin film and matt finish.    Doesnt stick like color print 2. That paper backer did not cooperate for me either."

"It is going to be a tougher sell without a stand"

"Free is Good"

"Did you get it to work. We just got some and had a few demo's from the manufacture., press on and then to puff you want no pressure hoover press lightly on top of film to puff   Siser aslo makes films for Stahls, I would guess IW.…"

"We got a VP300i a couple months ago, you can buy silver heat transfer material and you dont have to print silver than. Part of the reason we didnt get a VS was for garments we could not think of a real reason yet to be able to print white or silver,…"

"We got some miss labed carrier the other day too. Even though the width matched what it was supposed to be stretch print mask, it wasnt the right product it was TTD mask. this was from IW. This was about 2.5 weeks ago."

"We started with the Hotronix Auto Clam, love the auto opening part. The fusion is a manual open. We now upgraded to the Air Swinger which had dual timers, and auto open, but it will cost about $300 for a air compressor. I also noticed the air…"

"The only thing we didnt like with the fusion is it is not auto opening, so we bought the air swinger, it also has presets"

"N Glantz"