Started this discussion. Last reply by Steve Port Jan 5. 14 Replies 0 Likes
I just purchased a used XR-640 printer got it home and it prints just fine but its like the print is faded like its only putting on half the ink needed. the inks seem to be plenty full. The only…Continue
Ryan has not received any gifts yet
I hope you have the manual. Your nozzle test is not good, a lot worst out there, but not the greatest. When was the last time he changed the captop.
So the missing nozzles will cause banding - so will wrong profile and bad calibration - not really your issue.
Your calibration is slightly off - the slight gap in your nozzle test
The over printing - I believe it is your bi-directional that needs adjusting - or that is a close up of a raster image - if you print a vector and it looks like that - when the printhead goes from left to right it is dropping ink too soon.
The dull prints - not the ink - ink is never the cause - wrong profile and you are designing in CMYK - Do your work in RGB, Pantone, or Roland Color Library to get better prints
Set the correct profile in the quality tab in VW, in the printer tab, set all the settings to default media.
© 2018 Created by Steven Jackson - Admin.
Powered by