"Do you have a paper converter/slitter company near you? They might do it for a fee. If you are going to buy a lot of material that is to wide for your BN-20 you can also purchase a slitter.
"Edge curl will happen quite often when you cut into the printed ink. Your desire is to print and cut with no lamination and I suspect that you are cutting into the ink. The only real solution to this problem is to leave a small unprinted space…"
"If you need to keep lining up the slots I think I would make a jig with shaped pegs sticking up where the slot go. Pegs would maybe stick up about an inch, would have to experiment with that. Place the decal on the pegs then slide the decal down the…"
"I would agree with Irving on the use of Arlon DPF-8000 good sticky stuff. You might also try DPF-4560GTX or MTX they have air release adhesive that makes it easier to install. You may have to apply a laminate depending on desired longevity of the…"
"There was a Microsoft update that disabled a certain style of font because of a perceived threat. The disabling of the font was not intentional as it also caused problems with Microsoft's own software. I thought Microsoft corrected the problem…"
"Just getting setup to print OEM ag equipment decals that have a serial number on them. Going to use variable data feature to print those. They are printed in a "just-in-time" manufacturing situation.
"I experienced these same problem with Arlon supplied profiles along with black and magenta ink streaking together. This started after the last update. I already id the delete and reinstalled of the profiles, even downloaded them from Arlon…"