Mike K
  • Male
  • Canada
Share on Facebook
Share
  • Blog Posts
  • Discussions (3)
  • Events
  • Photos
  • Photo Albums
  • Videos

Mike K's Discussions

VP300 - Do I need new heads?

Started Jan 15 0 Replies

We just got our printer back from repair (hardware issues) and after a test print I have some major deflection. I have tried cleaning and printing solid bands to see if it would clear up but nothing…Continue

Position Invalid Out of Range - VP-300

Started this discussion. Last reply by Mike K May 31, 2018. 2 Replies

Hi there!We have a VP-300 main board go bad, so we replaced it and I am trying to run the reinitialize limits. I lock the carriage (making sure it's locked), start the process, slide the cutter all…Continue

Gifts Received

Gift

Mike K has not received any gifts yet

Give a Gift

 

Mike K's Page

Latest Activity

Mike K posted a discussion

VP300 - Do I need new heads?

We just got our printer back from repair (hardware issues) and after a test print I have some major deflection. I have tried cleaning and printing solid bands to see if it would clear up but nothing so far. Do I need new print heads or is there something I can do to clear the deflection?Thanks!20190115_161258.jpgSee More
Jan 15
Mike K replied to Mike K's discussion Position Invalid Out of Range - VP-300
"Thanks for the reply, our board was dead so we were unable to save the parameters from the original. I did manage to fix the error by setting it up as a vp-300 in the menu. I got past the limits part, had more errors and got through those... So the…"
May 31, 2018
irving donaldson replied to Mike K's discussion Position Invalid Out of Range - VP-300
"Yes it matters since the range of one is not the same as the other. You cannot just replace a board cold. It takes about 2 hours to set up a mainboard and there are dip switches that need to be set. A tech would pull the parameters off the old board…"
May 30, 2018
Mike K posted a discussion

Position Invalid Out of Range - VP-300

Hi there!We have a VP-300 main board go bad, so we replaced it and I am trying to run the reinitialize limits. I lock the carriage (making sure it's locked), start the process, slide the cutter all the way left, hit "enter", the cutter moves right, gets to the end, does it's wiggle but then I get:"Position Invalid Out of Range"Does anyone have any ideas? I'm new here and not 100% on the lingo so be gentle.a note: we have a vp-300 but when I boot up it says VP-540 on the LCD, not sure if that…See More
May 30, 2018
Mike K is now a member of MyVersacamm.com
May 30, 2018

Profile Information

Hometown: Please include City & State
Charlottetown PE
Core Business
Embroidery, Screen Printing
Your Position
Graphic Designer
Type of Printer/Cutter if owned:
VP-300

Comment Wall

You need to be a member of MyVersacamm.com to add comments!

Join MyVersacamm.com

  • No comments yet!
 
 
 

© 2019   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service