"I doubt if those nozzles could be aligned - But all your adjustments seem to be off - you need to align the cmyk to the black lines - you are looking for the thinnest line. Your service and user levels are off. Do those in service mode then check…"
"Hi again Irving! I did the tests you told me to try so i attached some pictures below. The problem is the light cyan head, as you can see, its almost impossible to calibrate the bi-dir and horizontal when you can't see vertical and horizontal…"
"If the machine was pumped-up the 2 months would have been fine. So you might be in need of another head soak at least 48 hours followed by a couple of powerful cleanings - waste of ink, but cheaper than a head.
In the service mode, check your bias,…"
"Hi Irving! Thanks for your time to answering my questions.
I bought my printer from Sweden so it has been at sea for about 2 months, at the beginning the yellow head refused to print any nozzles. I took a syringe, sucked out the ink from the head…"
"Nozzles look good except for yellow as stated
With nozzles looking that good and the yellow deflecting - might be due to blocked nozzles - try a 48 hour head soak with lines clamped and machine off - then 2 powerful cleans. See if that brings the…"
Hey guys! I'm a new member of this forum, i have seen you post a lot helpful comments and great ideas of how to fix roland printers. The case is that i my XC-540 has started printing blurry. Printhead seems to be in a great shape excepted for the yellow one which has some reflected nozzles. When i print cyan or a combination of it it leaves small drops on the sides of the print. I have tried to clean the encoder stripe but it didn't work, then i flipped the encoder did a linear calibration and…See More