Julie
  • Female
  • Gauteng
  • South Africa
Share on Facebook
Share
  • Blog Posts
  • Discussions (2)
  • Events
  • Photos
  • Photo Albums
  • Videos

Julie's Discussions

Roland cutting out

Started this discussion. Last reply by irving donaldson on Tuesday. 4 Replies

Good day. Please need advise urgently. My Roalnd versacamm VS540 keeps cutting out. For example, I print 200 little stickers, laminate them, and put them back to cut. The machine picks up crop marks…Continue

Gifts Received

Gift

Julie has not received any gifts yet

Give a Gift

 

Julie's Page

Latest Activity

irving donaldson replied to Julie's discussion Roland cutting out
"No need ever to disagree with anyone - no need to make assumptions especially since you did not post in which direction the labels were printed. It is a know issue and most confuse 8 linear feet with length and not the distance in blade travel,…"
Tuesday
chris wool replied to Julie's discussion Roland cutting out
"Within that area should be fine Things to consider  Stretch while laminating  Dull blade causing bunching of the media then goes out of alignment. Extra pinch rollers on 600 material you can get a 3rd one in. Think I noticed just the feed…"
Tuesday
Julie replied to Julie's discussion Roland cutting out
"Thank you so much. So this is a common problem and not just my machine that has a fault? Sticker are very small 60 x 15mm. Total 200 stickers is about 600 x 420mm"
Tuesday
irving donaldson replied to Julie's discussion Roland cutting out
"Yep you are trying to print too much at one time - good for only 8 linear ft of accuracy Set page length which will print and then cut after every few rows until job is complete It is called Print and Cut accuracy"
Monday
Julie posted a discussion

Roland cutting out

Good day. Please need advise urgently. My Roalnd versacamm VS540 keeps cutting out. For example, I print 200 little stickers, laminate them, and put them back to cut. The machine picks up crop marks and starts cutting. The first few lines it cuts right but the further down it goes, it cust out until finally at the end it is totally cutting into my print job area. We have made sure our blade is right, wheels are clean.. We have done a cut alignment test and done setting and it is still cutting…See More
Monday

Profile Information

Hometown: Please include City & State
Springs, Gauteng
Core Business
Graphic Designer, Promotional Company, Manufacturer
Your Position
Owner
Website:
http://www.envisiond.co.za
Type of Printer/Cutter if owned:
Roland VS 540

Comment Wall

You need to be a member of MyVersacamm.com to add comments!

Join MyVersacamm.com

  • No comments yet!
 
 
 

© 2018   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service