Geoff
  • Male
  • Whitby North Yorkshire
  • United Kingdom
Share on Facebook
Share

Geoff's Discussions

SP-300V print shifting ghosting?

Started this discussion. Last reply by Geoff on Friday. 1 Reply

My print and cut was misaligned, so I went through a lot of setup adjustmentrs in the service menu using the maint manual as well. Then on a forum I read something about linear calibration, I started…Continue

Do I need printhead replacement?

Started this discussion. Last reply by Geoff Oct 8. 3 Replies

SP-300V, I recon I need at least one printhead, what do you guys think?Any amount of cleaning, shringing through ink, soaking etc does not help.Printing black alone is fin, but as you can see in the…Continue

SP-300V servo problems

Started Sep 29 0 Replies

Had motor error 0010, blown servo card and scan motor was shot, I bought a new scan motor and had a electronics guy change both the motor driver chips on the servo board.The boot sequence was normal…Continue

Gifts Received

Gift

Geoff has not received any gifts yet

Give a Gift

 

Geoff's Page

Latest Activity

Geoff replied to Geoff's discussion SP-300V print shifting ghosting?
"Fixed it by going to Service menu - Head Adjust - Horizontal print test and adjust, working fine now."
Friday
Geoff posted a discussion

SP-300V print shifting ghosting?

My print and cut was misaligned, so I went through a lot of setup adjustmentrs in the service menu using the maint manual as well. Then on a forum I read something about linear calibration, I started to do this, but did it wrong and ended up with service call 0101, to cut a long story short, after much messing around I eventually reset everything to defaults in the service menu to make a fresh start. I then tried a test print/cut from a PDF via VW, it consists of a row of BLACK stars across…See More
Friday
Geoff replied to Geoff's discussion Do I need printhead replacement?
"I'm a fool, haha, when cleaning my printer last week, the mist filter was beyond service. I replaced it with a substitute, it was only this morning that I paid some attention to it, and realised it is bulging up in the middle. This has caused…"
Oct 8
Geoff replied to Geoff's discussion Do I need printhead replacement?
"Hi, thanks for the reply Irving. Cap tops are new, and no problem to draw Roland Eco-Sol Max ink through with the syringe, encoder strip been cleaned with rubbing alcohol with calibration done at the same time, yesterday. New pic attached."
Oct 7
irving donaldson replied to Geoff's discussion Do I need printhead replacement?
"how old is the captop when was the encoder strip cleaned last yes you need that head when you take pixs do the nozzle test seperate - that is more important than all others"
Oct 7
Geoff posted a discussion

Do I need printhead replacement?

SP-300V, I recon I need at least one printhead, what do you guys think?Any amount of cleaning, shringing through ink, soaking etc does not help.Printing black alone is fin, but as you can see in the pics, the black is contaminating the other colours.Thanks.…See More
Oct 7
Geoff is now a member of MyVersacamm.com
Sep 24

Profile Information

Hometown: Please include City & State
Whitby UK
Core Business
Other
Your Position
Owner
Website:
http://motograffics.co.uk
Type of Printer/Cutter if owned:
Roland SP-300V

Geoff's Photos

  • Add Photos
  • View All

Comment Wall

You need to be a member of MyVersacamm.com to add comments!

Join MyVersacamm.com

  • No comments yet!
 
 
 

© 2018   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service