A Digital Printing Network
white showing where it is not supposed to
Hi
I have some artwork that great good in versawrorks but isn't printing like it looks on the screen. Any suggestions would be great.
thanks
april
Replies to This Discussion
-
Permalink Reply by CYW on -
Transparency? Lens? at the bottom of the canoe?
Attach the file here (or send it to me April) and I'll be glad to take a look
Diane
-
Permalink Reply by Steven Jackson - Admin on -
can you attach the file from Corel so we can compare?? What looks different? It does look like your cut pressure was a little off :)
-
Permalink Reply by April Holder on
-
No I started to weed it before I noticed the problem.
- Attachments:
-
-
back.cdr, 109 KB
-
-
Permalink Reply by Steven Jackson - Admin on
-
April - I cannot get that to open with all of the fountain fills etc. properly. I think that may be part of the issue. Are you using Roland colors in the fountain fills? If not, then I would recommend flattening the image so there is no confusion on VC's part in uncompressing the image.
You could try a PDF X3 file format also and see if that works.
-
Permalink Reply by April Holder on
-
Yes I used roland colors I will try flattening it.
-
Permalink Reply by Steven Jackson - Admin on
-
BINGO! - you cannot do a fade from one Roland color to another - Versaworks will get very confused and give you issues. If the color is from 100% to another percentage, you will be fine. If you flatten it, the color will not be a RVW one anymore. Give me a call if you can April so we can dig deeper and get this fixed for ya.
-
Permalink Reply by April Holder on
-
You are the greatest!!!! that fixed the problem. Don't use versa colors in fountain fills. I have learned that lesson. Thank you so very much I am happily printing now.
Thanks
April
© 2013 Created by Steven Jackson - Admin.
