A Digital Printing Network
Wall Murals
Hey folks....any suggestions on tiling. I have two large murals I am working on. Have nothing printed yet. Just getting to it now. Read about the tiling, but am not sure of what I am looking at. I have to create 2 panels for both jobs and I have to overlap to register the print correctly. Is Versaworks in the tiling dialogue idiot proof? For Installation I'm thinking I Print and Cut, then trim excess by hand, then install and finish trim to existing parameters. Would you do it that way?
Thanks in advance for anyone's help!!
Jim Ashby
Replies to This Discussion
-
Permalink Reply by irving donaldson on -
Not idiot proof. It takes some getting used to. You go to the clip and tile section; pick your number of tiles; select which part you want to print first; click the side you do not; print that with or without alignment marks; VC can do the trim; remove after print; deselect the selected; select the next panel - check place alternate (if not they will not align - don't ask); print and then hang.
-
Permalink Reply by irving donaldson on
-
welcome
© 2013 Created by Steven Jackson - Admin.
