New to this site and have a problem with my printer not printing cyan, I think lite cyan. Only about 1% of nozzles on print test. When I do a lot of cleanings the cyan slowly comes back but after a printing a small graphic falls out again. When it falls out it starts printing a full color band of cyan where the magenta should be next to it and it’s band is totally blank. Not sure how it is moving over to the magenta. The two colors are not even on the same damper. Changed dampers and checked air in lines but no change. Did a ink renewal also but same results. Did all the head cleaning procedures but same results. Any ideas of what could be causing the problem.

Views: 33

Reply to This

Replies to This Discussion

post a picture of the nozzle test

RSS

© 2019   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service