Just replaced print head, cables, dampers and followed service manual procedure for installing these.

Did a test, and nothing prints.  Ink: lc, cy, lm, mg, ye, bk, wh, mt on a Roland VersaCamm VS-540i

Appreciate any help.

thanks

Views: 39

Reply to This

Replies to This Discussion

How does one start to help on this

not enough to go on - is this your first one, any training

did you enter the rank

did you start without the cables plugged in = head broke

did you plug cables in correct and properly seated = head broke

did you spill ink on the printhead board = head broke

RSS

© 2017   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service