A Digital Printing Network
Versacamm need to contour cut
I printed out my job and I have the contour cut guides but the vinyl came off the tracks to how do I tell the versacamm to just cut the print since it is already printed??
dave
dave
Replies to This Discussion
-
Permalink Reply by Butch on -
Did you print registration marks ? Without marks it is pretty much impossible to contour cut your job if you have removed it from the machine. The media must follow the same path that it took when it printed to contour cut . If you printed registration marks , reload media , have the machine find the marks, in VW go to job, open job settings, cut controls, operation mode ,chose cut only. Good luck with it.
-
Permalink Reply by dave conti on
-
yes I printed the registration marks I will give it a try. thanks
-
Permalink Reply by dave conti on
-
success!! thanks again
© 2012 Created by Adam Yukish.
