A Digital Printing Network
Versacamm Cutting
I am having one heck of a time getting my versacamm sp300 to cut completely. It's a relatively new blade and I've tried tweaking every setting imaginable. In the test cut, it cuts the circle well, but leaves a small notch in the same place (top) and the square does not cut all the way through. I've ordered a new blade, but I'll take any advice I can get at this point. Thanks, John.
Replies to This Discussion
-
Permalink Reply by Kevin Hirata on -
John,
For a period of time I was having problems cutting laminated vinyl. The corners on rectangular decals were being left uncut. I tried slowing the blade speed down from 30cm/sec to 20cm/sec. That along with a 60 degree blade seems to have taken care of the problem.
Kevin
-
Permalink Reply by Steven Jackson on -
A 60 degree blade should not be the answer. If you are switching blades, then you will need to change the offset. I think the problem is in that setting. It should be at 0.250. If it is at anything other than that, your problem might be there.
Hope this helps!
~Steven
-
Permalink Reply by John Morgan on -
It was the blade... I replaced the blade, moved everything back to 60 grams and default for everything and it is perfect now. When I compared the old blade with the new I could see it was worn away or chipped off. Thanks for your input.
John
© 2012 Created by Adam Yukish.
