USB ports

Replies to This Discussion

Permalink Reply by Mike F on November 16, 2011 at 3:43pm

Does the USB port that works for your HP also work for your 300v?

• ▶ Reply

Permalink Reply by Butch on November 16, 2011 at 4:28pm

have you set the usb in VW printer settings ?

• ▶ Reply

Permalink Reply by Peter on November 16, 2011 at 4:55pm

all the USB ports used to work for the VW printer... but now just one does.

it doesnt load the driver to read the USB for some reason

• ▶ Reply

Permalink Reply by irving donaldson on November 16, 2011 at 6:33pm

Not sure the issue - but I believe when the v series came out - the standard was usb 1.1 now we are in version 2.0 and think the next is knocking at the door.  2.0 cables and ports are backwards compatible so I would try a 2.0 cable and see. Unless the port is bad - that should give you the best chances of success. And yes for all others Roland switched to ethernet cables after the v series.

• ▶ Reply

Permalink Reply by Ken Wagner on November 16, 2011 at 8:33pm

You say it used to work but now doesn't.  Could be the port is just bad or connector damaged in some way.

• ▶ Reply

Permalink Reply by Peter on November 16, 2011 at 9:40pm

 port 1-2-3 work.. just port 3 works for printer, was just wondering if anyone came across this problem before. it seems like I am the first... usually when I plug it in it says driver being installed, this time it said driver not installed then the message went away... I can still run printer just from port 3... thanks to all who tried )

• ▶ Reply