Hi I was wondering if anyone on here has replaced the main pinch roller assembly's out before? found have been having some cutting issues, and so far have traced it back to both assembly's having cracks in plastic frame. I would like to get an idea if this is something I dare tackle on my own or not? Thanks in advance
Sorry for the late reply. Been super busy. It was a real bear changing those pins and springs. It was the worst part of the entire job however I did find a way to do it. I took photos of the entire process for next time. It involved using a set of punches, a hammer and a vice as well as safety glasses. I was also worried about loosing a spring or two. Not looking forward to doing it again however it went well and I have had no trouble with the rollers or frames since then. I will say that I now use the extra frames and rollers 95% of the time to take the stress off the two permanent ones. LMK if you want the photos and I will get them to you if you still need them. Just a note that I am not the one who makes the aluminum ones.
Regards, Jack Kertzie
Hi Jack, are you still offering the aluminum pink bodies? if so how much a pair? I also was wondering if there are any tricks to removing the pivot shafts from the old bodies? seems like they have a LOT of spring pressure, and making it difficult to get them out? Thanks
yes we still offer them best investment ever, 7168079536
are these for the middle pinch rollers i have searched hi and low and just cant find mine since the move
these are just the frames and they are just the outside units sorry
thanks for the reply
do you know where i could find some middle roller assembly's?
ANY ROLAND DEALER WILL BE ABLE TO SELL YA THEM, OR TRY SIGN-IN CHINA
thanks will do that