A Digital Printing Network

SP300V measurements

Hi there

I need to knowt the size of a SP300V whit 440ml cartdriges installed, because I'm remodeling a room to open a small shop here, and my printer is in a crate in storage, and doesn't make sense to set it up now just to measure it. Maybe some of you have that setup and have a minute to pass me those measurements, it would really help me think about the layout of the shop while we're still remodeling, saving me sometime.

I appreciate any help you guys can give me here

take care

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Roland R. Irish III on April 1, 2012 at 4:24pm

base is 29" , SP300 with 440ml probably 72". That's just the 'footprint' of the printer-you need room to get in behind to load rolls, and room in front to have a table or counter to catch long prints. I only have about 24" on either side of mine, one end against the wall-and it's very difficult to get around it-for long prints (no counter space available) I have to stand in front and roll up the material as it prints so it won't flop on itself. I do have the 'material catcher' below it, the half moon chrome rack, but not all material slides in it like it should.

▶ Reply

Permalink Reply by Carlos on April 1, 2012 at 5:30pm

Thanks a lot for the reply, it saved me a lot of headaches trying to figure out where's the best place for it.

I know what you mean about room around the printer, I suffered the same thing in my old place, but it wasn't used much, now it's gonna be used on a commercial enviroment which is different, so I'll keep that in mind for sure.