Return to Origin but not enough material - sheet end error detected

Hi All,

I misjudged the amount of material needed for a print job and I need to do an overprint/second pass. I printed with Return to Origin and I also printed crop marks (I need to laminate and cut) but when the print finished and it fed forward the sheet, i received the following message: Sheet End Error Detected. Please Setup Media Again."

Does anyone have a trick whereby I can feed this job in again so that I can print over it? I doubt it but I thought I'd let the clever people confirm it :)

I hope someone has a brainwave.

Thanks.

Views: 33

Reply to This

Replies to This Discussion

Tape a piece of media to the end of it

RSS

© 2018   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service