A Digital Printing Network
red is acting weird
hello again .. i was wondering if someone can help me out again .. whenever i print red it comes out with lines or bands in it ... its not that bad but i dont like it and i dont think it should be there .. i am using quickprint with either ttrh or htm2 .. max impact and pre press .. still same issue .. i have attached a picture to show what i am talking about .. side note: i just changed my cap top recently
thank you
- Attachments:
-
-
photo(12).JPG, 2.5 MB
-
Replies to This Discussion
-
Permalink Reply by chip on -
it looks to me that the media feed is not correct, I may be wrong but its worth a try to fix it it will show you how to do this in your manual. it always seems to be more noticable in reds
-
Permalink Reply by Steven Jackson - Admin on -
+1 on feed calibration
-
Permalink Reply by irving donaldson on -
You changed the captop - do all the calibrations like the first time. You have horizontal white banding which means feeding to fast. check calibrations as mentioned - but do the other test too.
-
Permalink Reply by Adnan Majid on -
thanks everyone for the help .. i used the spot color for red and then its fine .... i dont know how that is but its works now .. thanks again
© 2013 Created by Steven Jackson - Admin.
