Hi all!

Last week I had to set the offset to .375 for all media we cut.  Today a new Roland 60 blade arrived and when doing cut config on different media I had to set the offset to .325 so as to not have horns. I used compressed air to blew out the blade holder and used 3in1 oil drop into blade holder and replaced cutting strip with a new one. Does anyone know why with a new 60 blade the offset would have to be .325? Is this ok? Should I try some other troubleshooting?

Thank you in advance for your replies!

Roland VS-540

Views: 39

Reply to This

© 2018   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service