I have a my Versa Camm SP-300 and I use Flexi 19 software to run it.  Flexi had me do an update a bit ago and now my Contour Cut is off. The cut starts off too far to the Left and as it gets to the end (left side of the print) it progressively gets worse to the Right of the print

I have called Flexi and they had me do a Output Size Compensation test.

I checked the print cut test and the scan cut and both were fine.  I did the Auto print cut Adjust.  My cable is not too loose.  The Scan and Feed test were good too.

Nothing seems to fix this.

It was fine before the update.  I am running this on Windows 7 professional.

What do I need to do?

Views: 23

Attachments:

Reply to This

© 2021   Created by Steven Jackson.   Powered by

Badges  |  Report an Issue  |  Terms of Service