A Digital Printing Network
Masking Question
Hi,
I have been printing some larger logos on 4560GTX, and I'm unsure how best to mask these, only because of their large size. I'm sure this is a dumb question, so I apologize in advance, but is the mask that I use for Quickprint, strictly for garments/heat press? The mask that I have for the GTX is not tall enough for my design (35" high x 22" wide), and I'm afraid if I butt two pieces up to each other there will be a line on my logo. Any feedback is appreciated. Thank you so much in advance!
Replies to This Discussion
-
Permalink Reply by Butch on -
The masking for QP is for garment transfers only. When masking work larger than your masking you should overlap your masking by at least 1 inch - do not butt ends always overlap just like you would for a tiled graphic.
-
Permalink Reply by CYW on
-
I'm not sure I understand your question Stephanie but transfer tape is available in larger widths that will be more than sufficient to cover your design
But, you can certainly overlap 2 pieces if you don't have the wider width available....why would you think the tape will leave a line?
You shouldn't apply the tape if the print is not thoroughly dry
Use Transfer Tape not Quickprint mask
Di
© 2013 Created by Steven Jackson - Admin.
