Anyone know how to lower the cap tops without the tool?  I'm sure it can't be that tough just not sure if there is another way to lower them without that metal tool.

Views: 10

Reply to This

Replies to This Discussion

Not being smart, the tool is what makes it that hard. You will need something that fits the hole and the pin you are turning

hope this isn't a stupid question, but its a round peg...not sure what I could use to reach in there and turn that.  I'll see what I can do though...sounds like I don't need the tool anyway.

It is not round, for it would not be able to turn it, it would just spin

Like an allen key

It is needed to lower and raise the head, you will surely need it for flushing, for captop change, if the power goes out

RSS

© 2019   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service