Anyone know why this is happening? Also, does anyone have a recommendation for a good setting for printing reasonable resolution for prints used for signs and decals? I don't want photo quality because it takes FOREVER to print. (ie: it take 90 minutes to print a 2' x 2' print). I want reasonable resolution that will print that same 2' x 2' print in about 15 minutes or less. Thank you in advance for any help. Warm Regards, - Randy

Views: 90

Reply to This

Replies to This Discussion

I see banding - so check your calibration 

I see something dragging on your prints, so check your manual cleaning, you probably have lint or media attached to the printhead or head carrier.

You only need 72 dpi at print size to get a good print - so try 120 dpi, standard not hi-qual


© 2019   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service