Hello, I've been searching everywhere looking for someone to help me with my printing problem. I have an old 1989 Toyota MR2 that I have restored. The car has metallic pinstripes around the vehicle as well as metallic trunk decals. I have been looking for someone to recreate the original decals however that seems to be next to impossible for everyone that I have spoke with and had made samples.
What I am looking for and hoping someone here can help me or point me in the right direction is this...
PINSTRIPES - I need a clear piece of tape approximately 1cm wide with three 2cm wide metallic charcoal grey stripes PRINTED ON it - not three separate pieces of stripe. There will be a 2cm space between each stripe. The tape should be at least 30 inches long and I need about 30 feet of tape to do my whole car. And there should be a sliver of clear on each side of the stripes so as not trim off the colour when it's cut. See attached picture.
TRUNK DECAL - I need two trunk decals made, one that says Toyota MR2 and the other says Supercharged. These will be the same charcoal grey metallic with a silver border and each decal will be printed onto one piece of clear tape - not individually cut letters. See attached picture.
I know this sounds little ocd but I want the stripes and decals to be accurate replicas of the factory OEM decals. Of course the material will need to be vehicle-grade that will withstand the elements and not peel off.
The below pictures are of some samples I had made and they factory OEM correct however the colour is wrong - these are black.
I have the vector files... I just need to find someone who can print them in dark charcoal grey metallic. Can anyone help??? I've been working on this for over a year and most everyone I speak to says it's too difficult a job and not cost effective. I have the money... I just need to someone willing to do it.