So the head on stuck on media this morning while warming up.
I had to restart the VC Sp 300i and tried to print again & now its printing blurry. I ask a tech about it and he asked for a nozzle test and said it looks like a twisted head?

Views: 148

Attachments:

Reply to This

Replies to This Discussion

Looks like the yellow magenta Head has been knocked out of position.
Notice it's overlapping the cyan and the two passes don't line up in the feed direction.
I think it's far enough out to cause the fault in the first picture
Carer and attention to detail required to realign depending on your ability may want to get the tech over

RSS

© 2018   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service