In the process of restoring and XC 540 we were able to get most of the printheads cleaned. Two of them however are printing from every nozzle when performing a test print.

If I move the head to another location the problem follows the head. Any suggestions?

Views: 77

Reply to This

Replies to This Discussion

mine did that from a bad ribbon cable, ( i bent a One tooth on  the ribbon from previously pulling out the riboon cable)      then it blew the fuse on the motherboard from continuously printing with it like that see see if it would go away...

Thanks Sergio..  I'll give that a try


© 2019   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service