A Digital Printing Network
Cutting strip, Is alittle damage ok?
Hey guys, My SP300i has the original cutting strip and before today it was perfect with no scratches/cuts. I was cutting some cut vinyl on my machine that was super long cause the versacamm tracks better than my plotter and it went through and gave about a 2" scratch on the strip.
Should i replace it or do you think it should be fine for good registration on print/cut still?
Thanks!
Replies to This Discussion
-
Permalink Reply by Steven Jackson - Admin on -
Mine are much worse than that and no issues - I would worry about it if there is a deep gouge and you notice a change in your cutting with it but it takes a decent amount before it really gets affected.
-
Permalink Reply by irving donaldson on -
When it gets bad and you need a temporary fix until your new one arrives - whenever that may be - you can use a piece of scotch tape or just flip the other one over and push it back into the grove.
-
Permalink Reply by John Miller on -
Thanks everyone!
© 2013 Created by Steven Jackson - Admin.
