Has anyone ever had this issue?

Sometimes when I export from Corel my cut line doesn't completely show up in Versaworks. For example, I'll put a cut line around my graphic, export it as an eps, then bring it into Versaworks. When I zoom in to check the cut line I can see about 80% of it going around my graphic, but there is a section missing. At first I just thought the preview was missing it, but when it actually cut, it wasn't completely cutting...See attached graphic

 

Anyone seen this before?

Views: 1165

Attachments:

Reply to This

Replies to This Discussion

For me using CorelDraw, I place a Roland cut line around my graphic and make it 3.0 pt.  It will look a bit thick, but will always show the marching ants around the graphic and cut perfectly.  

...just my 2 cents....

RSS

© 2018   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service