Contour Cut

Need help!  So I am using flexi along with versaworks. When i go to contour cut anything it cuts 99% of what I need but is leaving a very small part uncut. So for example, if i print a circle then it goes back and contour cuts it but leaves about 1/8" not cut... Does anyone know why this is happening? Its very frustrating.... Thanks for any help 

Views: 111

▶ Reply to This

Replies to This Discussion

Permalink Reply by Todd Collins on October 4, 2018 at 2:39pm

Hi Jeremy.

I didnt see this post earlier, so I hope you've gotten it figured out by now.

Add an EPS margin to the file format tab in your versaworks....

RSS

© 2019   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service