I'm getting some bleed over on the yellow/magenta when I do a test print.

I am using the Roland SP-300V

Just recently changed capping stations.

Normally I would think this would mean I need a new cap, but since I just recently replaced them (like within the last 3 weeks) I am not sure what's going on this time.

Views: 87

Reply to This

Replies to This Discussion

Check drain line for  a clog. You can put cleaning solution into captop until it drains quickly .If it doesn't drain remove and clean the tee connector. Be careful these become brittle and break easily.  Another may be a week or not seated spring in the captop.


© 2019   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service