MyVersacamm.com

A Digital Printing Network

Tim Hawkins's Discussions (62)

Search Forum

View

Discussions Replied To (46) Replies Latest Activity

"I have tried initializing....when you initialize does it delete all the jobs from th…"

Tim Hawkins replied May 13 to Versaworks Slow to load and freezes during loading any way to clear job queue without starting versaworks?

 11 May 13
Reply by Steven Jackson - Admin

"Steven,,,, Not sure as now I can't get it to start....is there a way to find that wi…"

Tim Hawkins replied May 13 to Versaworks Slow to load and freezes during loading any way to clear job queue without starting versaworks?

 11 May 13
Reply by Steven Jackson - Admin

"I will check the temp folder.....I have deleted about 80% of the jobs from the job q…"

Tim Hawkins replied May 13 to Versaworks Slow to load and freezes during loading any way to clear job queue without starting versaworks?

 11 May 13
Reply by Steven Jackson - Admin

"It finally loaded after 2 + hours.   Not Sure what is going on, I have a job I added…"

Tim Hawkins replied May 13 to Versaworks Slow to load and freezes during loading any way to clear job queue without starting versaworks?

 11 May 13
Reply by Steven Jackson - Admin

"Well,  here is what happened, the trough that the encoder strip seats into got a pie…"

Tim Hawkins replied Feb 15 to Major Problem I think.

 5 Feb 15
Reply by Tim Hawkins

"No Dice,  Started to print, then said carriages were disconnected."

Tim Hawkins replied Feb 2 to Major Problem I think.

 5 Feb 15
Reply by Tim Hawkins

"Upon further investigation, the encoder strip had slipped out of the sensor!  I got…"

Tim Hawkins replied Feb 2 to Major Problem I think.

 5 Feb 15
Reply by Tim Hawkins

"Blue ALert - http://www.facebook.com/BlueAlertLLC?ref=ts Seaglass Logowear - http://…"

Tim Hawkins replied Dec 12, 2012 to Facebook sharing anyone?

 21 May 7
Reply by Dustin Hamlett

"Ok, got  it fixed, ran it through normal cleaning...no luck, then ran powerful clean…"

Tim Hawkins replied Jun 27, 2012 to HELP! Black Ink ran out, now not printing.

 2 Jun 27, 2012
Reply by Erik Causevic

"I was having this problem, I had a brand new Roland blade in and the cutting was hor…"

Tim Hawkins replied Jun 20, 2012 to Cutting Problem

 10 Jun 20, 2012
Reply by Dennis Dunning

RSS

© 2013   Created by Steven Jackson - Admin.

Badges  |  Report an Issue  |  Terms of Service

Sign in to chat!