Todd Collins's Discussions (88)

Search Forum

View

Discussions Replied To (87) Replies Latest Activity

"Replace your wipers and felts. "

Todd Collins replied Nov 26 to Horizontal solid yellow & solid light magenta stripes

 18 Nov 30
Reply by Eric Wyatt

"last thing to try before the main board is a new encoder strip and sensor."

Todd Collins replied Nov 13 to Venting!!! over the stop mid print (also open to suggestions)

 13 Nov 25
Reply by Sam

"yes, I do....."

Todd Collins replied Nov 13 to refurbish roland printer

 2 Nov 13
Reply by Todd Collins

"Have a look at the grit encoder wheel. If it's clogged with debris or the lines have…"

Todd Collins replied Nov 3 to URGENT * VS-540 load material error

 1 Nov 3
Reply by Todd Collins

"IF you can find somewhere to replace the network chip, that would be a cheaper try t…"

Todd Collins replied Nov 3 to Venting!!! over the stop mid print (also open to suggestions)

 13 Nov 25
Reply by Sam

"Its the main board. The ONLY other option(s) is that your que is so full in VW that…"

Todd Collins replied Nov 3 to Venting!!! over the stop mid print (also open to suggestions)

 13 Nov 25
Reply by Sam

"huh? this is a simple decal to produce on a VS machine with metallic ink."

Todd Collins replied Oct 28 to Help needed to print Metallic decals

 14 Nov 9
Reply by irving donaldson

"the pink is the cut LINE color. You're using it to fill the entire area you want cut…"

Todd Collins replied Oct 28 to Help needed to print Metallic decals

 14 Nov 9
Reply by irving donaldson

"these are usually cured with new long ribbon cables also check the alignment of all…"

Todd Collins replied Oct 27 to Very feint magenta lines in blank areas of print runing down the sheet (not across)

 7 Oct 27
Reply by chris wool

"cutline color needs to be a stroke and not a fill."

Todd Collins replied Oct 26 to Help needed to print Metallic decals

 14 Nov 9
Reply by irving donaldson

RSS

© 2018   Created by Steven Jackson - Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service